Our Services
Radiator Installation
About This Service
Radiator Installation Done Right
James supplies and installs new and replacement radiators across Solihull and the surrounding areas. Each job begins with an assessment of the room, existing pipework and heating system. Suitable radiators and thermostatic valves can then be installed before the system is refilled, tested and balanced.
Why Choose us for Radiator Installation?
All radiator and heating work is completed personally by James, who is qualified, fully insured and Gas Safe registered.
TRVs and system balancing minimise cold spots and reduce unnecessary run time, so radiators heat evenly and your central heating performs more efficiently.
Independent local engineers serving Hall Green, Solihull and surrounding towns, offering tidy installs, clear advice and Verified by Expert Trades assurance.
How It Works
1. Site survey and specification
We measure room heat loss, check pipe access and note any pipework or decoration constraints so we can recommend the correct radiator type, size and TRV placement.
2. Supply and professional fit
We source the specified radiators, brackets and TRVs, then remove old units where required and fit the new radiators with neat, coded pipework and secure fixings.
3. Flush, balance and commission
After fitting we purge and, if needed, powerflush the circuit, fit thermostatic radiator valves, balance outputs room-to-room and complete a safety and performance check.
Frequently Asked Questions
Find answers to common questions about our services and process.
Yes. We fit TRVs to individual radiators to give room-by-room temperature control. TRVs are included in the specification stage so we can place them where they work best, and we commission them during balancing to ensure reliable operation.
We can relocate radiators and reroute pipework with tidy finishes. We always leave pipes ready for decorating and can recommend local plasterers if you need a plaster return, though plastering is quoted and scheduled separately from the plumbing work.
In most domestic systems a new radiator will integrate without issue, but we check flow and return temperatures and pipe sizes during the survey. Where the system needs attention we advise on options such as powerflushing or adjusting pump settings to improve circulation.
Yes. Balancing is a standard part of our install process. We set lockshield valves and check output room-to-room so radiators heat evenly rather than some overheating while others remain cold.
Times vary by scope, from a single radiator swap completed in a few hours to a whole-house upgrade taking multiple days. We give a clear timescale at survey and work to minimise disruption while keeping workmanship precise.